Toolcraft bcg's, AERO uppers/lowers.
Spez: all in 7.62x51
I got a D50 but it was always jamming, so thinking I might just got a dud, I got another one and it runs just as reliably (like shit). Tried it in multiple builds with different ammo. The bolt ends up sitting in and denting the middle of the casing when trying to feed. Is this a known issue?
tightening down, easing off,
Admitting it's effectiveness at the cost of my dignity. Good advice.
Fuckin beautiful.
skynet terminate u/ShoddySubstance
Our only hope is a mass understanding of the truth.
This is not conspiracies.win
Control yourself.
I got some kindve pirate musket and wet powder I hate holidays.
fuckin amen
Kyle Rittenhouse.
Not meth.
I find it easy to believe some retarded order following commie, or a 12 year old made this website. I'm leaning towards the former.
All gun laws are infringements and taxations are theft.
What exactly is preventing you from timing with a single crush washer?
I'm not sure. I've gone almost 360° with m4 brakes but the bigger gals I can't get more than 60° without jumping up and down on my vice handle to keep the barrel in place.
Flat washers may work but I don't see any advantage to using them instead of another crush as long as it doesn't look like garbage.
.win: I'm assuming the added 64th of an inch can't be beneficial.
"….. taxation is theft"
- Mahatma Gandhi
Plzshare 'try it faggot' gadsen.
Wondering why 21 isn't an option.
When I try to install m5 muzzle devices with more than two ports, I usually have to use 2 crush washers. Do I have gai?
Flannel daddy got me a month for a buck. The comments are accurate, but I probably already saved a buck.
Listen fat. Corn pop was a bad dude.
Please clarify, not sure which things should gib boner.
I'm too retarded to know what's going on here. No.
Looks like some pissing hot loads. I can hear the crunch.
These two, that's who.
Skynet initiate gib poops u/CommiesArentPeople