Poverty pony gets yet another upgrade, now what to do with the trash?
(media.weekendgunnit.win)
Comments (25)
sorted by:
Get a new lower and start new build.
You know the rules, and so do we.
A full commitments what I'm thinkin of.
You get this from a picture of my feet
You wouldn’t get it from any other limb.
Platinum rule, faggot.
No 3rd hole.
Big ghey.
Nice fed post, I'll show you my yankeeboogle if you show me yours.
The fact that you didn't already have another build started suggests sexual deviancies in your past
New build make the most dangerous to the user AR-15 possible
Would a drill press, rusty screwdriver, and a 2x4 be dangerous enough or should I use particle board?
Use as many low grade polymer parts as possible including a 3D printed receiver. Make sure there is a 50/50 chance it turns into a grenade with each shot
Instructions unclear. 3d printed dildo screwdriver stuck in rusty drill press. Drill press now in bedroom sideways helping meth with 'research'. Need new drill press. And paracord.
Who told you?
You've honestly got me thinking here.
Has anyone tried machining an AR-15 lower out of wood yet? I can't think of a single reason that a good chunk of solid oak wouldn't be perfectly viable as an AR lower receiver.
The only problem I can think is that the dimensional stability of the wood might not be good enough to preserve the relationship between the fire control components, resulting in unintentional hammer fall. You might have to stick a small steel plate in there to keep the hammer and trigger pins in proper alignment.
Might also have to beef up the cross section a bit where the stock attaches -- but that's solved easily enough by making the stock integral to the lower receiver.
The upper could be more of an issue -- you'd need some aluminum inserts for the cam pin to ride on to ensure you don't get out of battery fire. Perhaps an aluminum ring for the barrel to screw into to also serve as the rear sight platform. That isn't really a pressure bearing joint though, is it?
https://www.youtube.com/watch?v=MKHCZcmHi7Q https://www.youtube.com/watch?v=XFadMmT5ZQ8 I think I saw someone else make one out of either a 2x6 or 2x8 at one point too, but can't find it now
What's the other 3d print that's not the fgc-9? Uses a Glock barrel and mag, Doesn't use have a buffer tube specifically.
mod-9 my dude also known as the wtf-9 made by Mussy
you have parts, must build new
3D print something bad
Revolvers always work..........just think defensive....
Like the law tactical folder bits over a collapsible like maxim?
Shitbot quality post give poop
Super Dynamic Enhanced
Lulz
Send it.